• ADDRESS:
  • 1324 S. Flower St
  • Los Angeles, CA 90015
  • Tel: 213.663.1400

STORE HOURS:

Follow us on Instagram!

Mon - Fri 11:00AM - 4:00PM

 Sat 11:00AM-3:00PM

Closed Sunday

 

 

Original Store ! Carpe Diem:

3820 Valley Blvd Suite i, Walnut, CA 91789

Close
Search

Acrylic Clear Sheets Gloss/Gloss, Matte/Gloss; Extruded Gloss/Gloss

** Unless otherwise noted, all products have paper masking.

Cast Acrylic is a form of poly(methyl methacylate) (PMMA).  The sheets are produced by pumping the acrylic liquid, MMA (Methyl Methacrylate monomer) between two glass plates. The glass / monomer is then submerged in warm water and the process of polymerization takes place. The result is a sheet of rigid PMMA (polymethyl methacrylate) or what is generically called Acrylic. The smooth surface from the glass produce a gloss finish while a sutle frosted textured on the glass surface will yield a matte finish. The chemical process in the mold create a homogeneous material with equivalent properties in all directions. These conditions make it ideal for laser cutting and engraving in any direction.

  • Laser Cutting - the cut edges are polished
  • Laser Engraving - produce a matte white
  • Malleable / pliable when vacuum forming or hot wire line bending

Thickness available :

.031" (1/32) , .060" (1/16) , .118" (1/8) , .177" (3/16) , .236" (1/4)

Extruded Acrylic sheets are manufactured by a continuous production process. Acrylic or PMMA pellets are fed from a containment silo to a feed hopper above an extruder line. The pellets are fed into the extrusion barrel and are driven through the barrel by a single or twin screw auger system. As the pellets progress through the heated zones of the extruder barrel the heat increases until the pellets melt into a molten mass.

  • Laser Cutting - edges can look a bit different depending on the direction of the acrylic extrusion
  • Laser Engraving - produce a matte gray almost clear
  • Heat bending or thermoforming - behave differently depending on the bending direction relatively to the extrusion

Thickness available :

.060" (1/16)