Ultra Cutter Zo series -91

Ultrasonic cutter

40,000 ultrasonic vibrations per second with non-audible sound to assist in reducing the friction during the cutting process.Cutting modes can be switched by the output mode switch. Normal mode runs for about 10 minutes. High mode runs for about only 5 minutes due to rapid temperature rise. A temperature sensor is equipped inside of the hand-piece. In case the temperature rises, it stops the ultrasonic vibration and oscillation light blinks.

Plastic scale models, military models, railway models, mini4WD, figure, dioramas, dollhouse, gourd hole drilling, cartonnage, cardboard craft, deburring in garage kit production, printed circuit board pattern modification, white metal and wood cutting in sailing ship model making.

Examples of material cutting (estimate)

Cardboard: less than 2mm (0.079in)

ABS: less than 3mm (0.118in)

PET: less than 3mm PP and Acrylic: less than 3mm For hard materials or continuous usage (greater than 10 min.) consider the USW335-Ti cutter

Cuttable Materials 

Plastic : ABS, Acryl (PMMA), Nylon – Polyamide (PA), Polyamide, (PA) – Nylon, Polycarbonate (PC), Polyethylene (PE), Polylactic, Acid (PLA), Polypropylene (PP) and Polyvinyl Chloride (PVC).

Carbon, cardboard, cloth, epoxy resin, fossil, goard, gypsum, leather, metal, paper, paronia (Foam sheet), plasticine, polyurethane, silicone and wood.

ZO series could not cut Stone, Glass and Metal.

Comes with:

• Blade anchor ZH04 1
• Standard blade HA04 1 pack of 40 
• Blade anchor screw HB03 3
• Hexagon wrench RR02 1

Locked “ON” activation switch – 10 minute operation.  Switchable between NORMAL and HIGH Power for difficult to cut materials (5 minute operation).

AC adapter　INPUT: 100 – 240 VAC 50/60 Hz　OUTPUT: 12 VDC

Max. power consumption Max. 85 VA

Circuit Protection Over-temperature thermostat circuit

10 °C - 35°C (50°F - 95°F)

‎12 Volts

Extra Blades and accessories sold separately