Foam-Cure™

FOAM-CURE™ ( for porous materials )

To obtain a faster initial bond when bonding two pieces, FOAM-CURE™ can be applied to one piece and after the two are joined, they can then be pulled apart. After letting it air dry for about ten minutes, FOAM-CURE™ will act like a contact cement when the parts are rejoined, resulting in enough tack strength to allow the next steps of assembly. Full strength is reached in 10-12 hours.

It will bond wood and plastic to foam, and is a good canopy glue.  If one tried to bond, for example, a half-dollar coin to glass, over 90% of the adhesive would never cure, since the solvent it contains would have no where to evaporate. A small amount of denatured alcohol can be mixed into the Foam-Cure to make it thinner.

• Crystal clear
• Silicone based
• Not instant bonding like CA and there is no accelerator to speed it’s curing
• Works very well on EPP and EPO foams and will actually bond most other materials / foams
• Does not cure flexible enough to act as a hinge for aircraft control surfaces
• Requires exposure to air for drying