• 1324 S. Flower St
  • Los Angeles, CA 90015
  • Tel: 213.663.1400


Follow us on Instagram!

Mon - Fri 11:00AM - 4:00PM

 Sat 11:00AM-3:00PM

Closed Sunday



Original Store ! Carpe Diem:

3820 Valley Blvd Suite i, Walnut, CA 91789



FOAM-CURE™ ( for porous materials )

To obtain a faster initial bond when bonding two pieces, FOAM-CURE™ can be applied to one piece and after the two are joined, they can then be pulled apart. After letting it air dry for about ten minutes, FOAM-CURE™ will act like a contact cement when the parts are rejoined, resulting in enough tack strength to allow the next steps of assembly. Full strength is reached in 10-12 hours.

It will bond wood and plastic to foam, and is a good canopy glue.  If one tried to bond, for example, a half-dollar coin to glass, over 90% of the adhesive would never cure, since the solvent it contains would have no where to evaporate. A small amount of denatured alcohol can be mixed into the Foam-Cure to make it thinner.

  • Crystal clear
  • Silicone based
  • Not instant bonding like CA and there is no accelerator to speed it’s curing
  • Works very well on EPP and EPO foams and will actually bond most other materials / foams
  • Does not cure flexible enough to act as a hinge for aircraft control surfaces
  • Requires exposure to air for drying